Posted on 2 Comments

Klipper guide “complete but Coffe installed with me on phone and gave his feedback on making klipper noob friendly so will be adjusting and also working on the other configs more so it still is a WIP for ease of install”

To view this content, you must be a member of Advanced3dPrinting Patreon at $1 or more
Already a qualifying Patreon member? Refresh to access this content.

2 thoughts on “Klipper guide “complete but Coffe installed with me on phone and gave his feedback on making klipper noob friendly so will be adjusting and also working on the other configs more so it still is a WIP for ease of install”

  1. I was looking at your website and noticed it appears this link is broken: https://advanced3dprinting.com/wp-content/uploads/2021/06/a3dp_raspicam_mount-v12.step

    I had similar problems on my site until someone mentioned it to me and I also now use software from DeadLinkDetect.com to keep my site error free.

    1. Thankyou ill fix

Leave a Reply

Your email address will not be published. Required fields are marked *