BTT Octopus v1.1 (non-Pro) Klipper Firmware — download prebuilt bins (version-matched)
Prebuilt Klipper firmware for the BTT Octopus v1.1 (non-Pro), compiled by CI straight from the official
Klipper source at release latest release. Every binary on this page uses a curated,
reviewed configuration — the MCU, bootloader offset, clock reference and communication interface come from
Klipper's own documentation for this exact board, so you never have to run make menuconfig yourself.
Not your board? See the full Klipper firmware download portal.
⚠️ Octopus v1.1 (non-Pro) bins must NOT be used on an Octopus Pro v1.1 — wrong pin mapping can enable a heater inadvertently.
Downloads — Klipper latest release
| Variant | Interface | Download |
|---|---|---|
| f446-usb | USB / serial | Download |
| f429-usb | USB / serial | Download |
All bins and their exact build configs are attached to the GitHub release (sha256 checksums included in the portal manifest). Source code: Klipper is GPLv3 — the exact commit each bin was built from is linked in the release notes.
How to flash — SD-card flashing
- Copy the downloaded `.bin` to the root of a FAT32-formatted microSD card (≤32 GB).
- Rename the file exactly to `firmware.bin` (no other `.bin` file may remain on the card from a previous flash).
- Power the board OFF, insert the card, power ON.
- Wait 30–60 seconds. The board's status LED usually blinks during the flash.
- Power off, remove the card, and check the card on your PC: a `FIRMWARE.CUR` file means the flash succeeded.
- Reinsert the card only if your config reads files from it, then connect the host.
Configuration provenance
klipper: config/generic-bigtreetech-octopus-v1.1.cfg — F446: 32KiB bootloader + 12MHz; F429: 32KiB + 8MHz. Cross-checked 3dwork btt-octopus-11 (F446).
Related guides
- Klipper install guide
- Remote monitoring shootout — OctoPrint, Obico, OctoEverywhere & more
- Remote access with Tailscale (no cloud, no monthly fee)
- Moonraker API keys, explained
Firmware is built by automation from reviewed configs and is not hardware-tested per target. Klipper © Kevin O'Connor and the Klipper project (GPLv3).
