Creality 4.2.2 (Ender 3 V2 and similar) Klipper Firmware — download prebuilt bins (version-matched)

Prebuilt Klipper firmware for the Creality 4.2.2 (Ender 3 V2 and similar), compiled by CI straight from the official Klipper source at release latest release. Every binary on this page uses a curated, reviewed configuration — the MCU, bootloader offset, clock reference and communication interface come from Klipper's own documentation for this exact board, so you never have to run make menuconfig yourself. Not your board? See the full Klipper firmware download portal.

ℹ️ The 4.2.2 has no onboard USB-serial port; use the USART1 bin with a USB-TTL adapter, or the USART3 bin wired to the LCD port.

Downloads — Klipper latest release

Variant Interface Download
usart1 USB / serial Download
usart3 USB / serial Download

All bins and their exact build configs are attached to the GitHub release (sha256 checksums included in the portal manifest). Source code: Klipper is GPLv3 — the exact commit each bin was built from is linked in the release notes.

How to flash — SD-card flashing

  1. Copy the downloaded `.bin` to the root of a FAT32-formatted microSD card (≤32 GB).
  2. Rename the file exactly to `firmware.bin` (no other `.bin` file may remain on the card from a previous flash).
  3. Power the board OFF, insert the card, power ON.
  4. Wait 30–60 seconds. The board's status LED usually blinks during the flash.
  5. Power off, remove the card, and check the card on your PC: a `FIRMWARE.CUR` file means the flash succeeded.
  6. Reinsert the card only if your config reads files from it, then connect the host.

Configuration provenance

klipper: config/printer-creality-ender3-v2-2020.cfg — F103, 28KiB bootloader, USART1 PA10/PA9 (or USART3 PB11/PB10 on the LCD IDC).

Related guides

Firmware is built by automation from reviewed configs and is not hardware-tested per target. Klipper © Kevin O'Connor and the Klipper project (GPLv3).